We have upgraded our race proven MAK Hurricane Inlet Pipe once again for the Mustang GT S550 Procharger HO/Stage 2 System by adding our Monster 4.5 Inlet Pipe System.
- MAK 5+ layer Silicone Elbow with Aluminum Piping with 3/8 NPT Bung
- Increase approximately +40HP and +18TQ and +1 PSI of boost with no other changes in higher boost combinations where airflow restrictions results in a loss of Horsepower and Torque
- Replace the stock Prochager Inlet with our "NEW" 4.5 Inch Inlet with a Monster sized power stack 12 inch long air filter made by S&B Filters
- Improves Airflow and Efficiency to the Procharger by increasing inlet diameter and filter surface area
- 4.5 Inch Aluminum Pipe with 3/8" PCV Bung in Gloss Black Powdercoat Finish
- Extra Large S&B PowerStack Air Filter
- Custom made MAK 5+ layer Silicone Elbow Coupler
*** Inlet "WILL" fit with the Procharger Red Race Valve as long as it is located in the front bumper area. It will "NOT" fit the "older locations" of the Procharger Red race valve which was located inside the engine compartment, next to the frame rail.
Installation Recommendations: Trimming of the Silicone Elbow will be required depending on which stage procharger kit you have. This Inlet system is a very tight fit but it is worth every horsepower you gain !